Jinming Zhou
Titel
Professor
Organisation
046-222 86 01
Jinming [dot] Zhou [at] iprod [dot] lth [dot] se
Publikationer (hämtat ur Lunds universitets publikationsdatabas)
författare
- 2013
- 2012
- A Sustainable Approach for Milling of Duplex Stainless Steel by Increasing the Cutting Tool Utilization
- An investigation of surface damage in the high speed turning of Inconel 718 with use of whisker reinforced ceramic tools
- Characterization of mechanical properties of machined surface by nanoindentation — Part 1: Simulation of indenter geometry effects
- Comprehensive dynamic analysis of vibration and stability when ultrahigh speed turning Inconel 718 with cBN tools
- Effect of Cutting Conditions on Machinability of Superalloy Inconel 718 During High Speed Turning with Coated and Uncoated PCBN Tools
- Effect of cutting speed on machinability of Alloy 718 with conventional and binderless cBN tools
- Identification of Subsurface Deformation in Machining of Inconel 718
- Modelling Subsurface Deformation in High Speed Machining of Inconel 718
- Performance and wear mechanisms of whisker-reinforced alumina, coated and uncoated PCBN tools when high-speed turning aged Inconel 718
- Simulation of indenter geometry effects in nanoindentation
- Study of surface quality in high speed turning of Inconel 718 with uncoated and coated CBN tools
- 2011
- Characterization of White Layer Generated when Turning Aged Inconel 718
- Effects of Tool Wear on Subsurface Deformation of Nickel-based Superalloy
- Indentification of Subsurface Deformation in Machining of Inconel 718
- Modelling tool life in the machining of strain-hardening material - Alloy 718
- On the analytical representation of chip area and tool geometry for the case of oblique turning with chamfered round tools. Part 1: Chip area parameters under both side and back rake angles variation
- On the analytical representation of chip area and tool geometry for the case of oblique turning with chamfered round tools. Part 2: Variation of tool angles along the edge line
- On the surface quality of Alloy 718 in finishing turning with CBN cutting tools
- Process induced subsurface deformation of Alloy 718 in relation to different cutting conditions
- Study on work-hardening phenomena in machining aged Alloy 718
- 2010
- 2008
- 2007
- 2004
- 2003
- 1998
- 1997
- Analysis of Mechanical Load in the Cutting Tool at Entry and Exit Phase of the Intermittent Cut
- Cutting Tool Fracture Prediction and Strength Evaluation by Stress Identification Part I: Stress Model
- Cutting Tool Fracture Prediction and Strength Evaluation by Stress Identification, Part II: Experimental Studies
- 1996
- 1995
- 1994
